Specifications include, but are not limited to: purchase and installation of Six (60 Outdoor Warning Sirens; All products shall be manufactured with American Made components. Bidder shall have parts and service facility within 100 miles. Warning Siren System Shall Include: - The siren must meet or exceed the recommendations in the FEMA Outdoor Warning Systems Technical Bulletin 2.0 dated January 12, 2006 - The siren must be classified as commercial off-the-shelf - The siren must be capable of producing a three to five minute steady signal - The siren must be capable of producing a three to five minute wavering, warbling or attack (e.g., short blast) signal - The siren must have a backup capability to allow for a minimum of 15 minutes of alerting time - The siren must be rated at a minimum of 125dB(C) at 100 feet. - The siren must have an estimated 70dB(C) effective range of no less than one (1) mile distance in all directions - The siren motor contactor should be housed in a NEMA 3R or higher rated enclosure -The siren controller must be housed in a NEMA 3R or higher rated enclosure -The siren controller must be capable of 4 siren functions/run patterns and must be capable of activation via VHF wireless radio and either DTMF or 2TS tone codes. -The siren must be a complete turnkey Installation including a disconnect and on-site testing and training - The height of the siren must be a minimum 45’; on a Class I or II utility pole - The siren head warranty must be a minimum of seven (7) years - The siren battery bank must use 12V DC, gel cell batteries from a brand name battery manufacturer - The siren installation shall include all power supplies, rectifiers, transformers - It is preferred that the siren be installed using AC power with DC battery backup. DC battery primary systems will be considered.