All correspondence must be made through the Vendor Portal. Specifications include, but are not limited to: Shawnee County is soliciting bids commercial waste containers for use in its solid waste activities; (Front-load) Container: • 1 yard thru 8 yard all side panels must be 12-gauge steel. (No seams). • 1 yard thru 8 yard bottom must be 10-gauge steel. (No seams). • 12-gauge formed top channel around container top. • 3/16” flared fork pockets. • 3/16” gusset welded on the rear top and bottom side of the pocket for added pocket strength. • 3/16” Front bumper to prevent damage to the container. • 10-gauge full length bottom channel support. • 1 yard thru 8 yard containers must have (4) 7 gauge caster pads. • 1/2” lid rod supported by 3/16” steel brackets welded to the steel frame. • 1 ½” Removable drain plug. • Container must be primed inside and out. (Rear-load) Container: • Containers shall have front panel sloped to allow for ease of dumping • 1 yard thru 8 yard all side panels/bottom must be 12-gauge steel. (No seams). • All corners must have continuous welded seams for strength. • 12-gauge formed top channel around container top. • 1” solid steel winch hook welded in the center on the outside of the top channel for dumping. • Trunnion Bar: • 1, 2 yard container 1 3/8” solid steel bar with keepers welded on both ends. • 3, 4 yard container 1 1/2” solid steel bar with keepers welded on both ends. • 6, 8 yard container1 3/4” solid steel bar with keepers welded on both ends. • 11/2” Removable drain plug.
