Specifications include, but are not limited to: 1. Size 10 foot, two-section, pull-type _____ _____ _____________________ 2. Drive a. All drive components shall be Bondioli & Pavesi, Weasler or approved equal _____ _____ _____________________ b. 1000 RPM PTO driveline, Cat 5, or Cat 6 rating - 20 spline _____ _____ _____________________ c. Blade tip speed center section minimum 15,500 FPM -minimum _____ _____ _____________________ d. Blade tip speed wing section minimum 15,000 FPM -minimum _____ _____ _____________________ e. Two or three gear box drive _____ _____ _____________________ f.250 HP divider gearbox _____ _____ _____________________ g. 200 HP section gearbox _____ _____ _____________________ h. Constant velocity input drive shaft _____ _____ _____________________ i.Round splined ii. Plastic shield _____ _____ _____________________ iii. 80 degree working angle _____ _____ _____________________ i.Heavy duty section drive shafts - Cat 5, or Cat 6 rated _____ _____ _____________________ i.Plastic shields _____ _____ _____________________ j.Slip clutches to protect each drive line _____ _____ _____________________ k. Antifriction sealed bearings _____ _____ _____________________ l.Round-type skid pan (stump jumper) _____ _____ _____________________ m. Manufacturer's standard blade rotation _____ _____ _____________________ n. Free swinging updraft blades _____ _____ _____________________ o. Readily accessible ports for driveline lubrication (ability to lubricate without use of tools) _____ _____ _____________________ p. Cutting capacity 4" material
