Specifications include, but are not limited to: Capacity: Articulated platform truck with one (1) platform, working load of 700-pounds, height from ground to platform floor to be 75-feet when mounted on truck chassis, working radius from center line of rotation to be 46- feet, overall height from ground in travel position to be 13-feet maximum, lower boom travel to be 0 degrees to +88 degrees, upper telescopic boom travel to be -25 degrees to +75 degrees, rotation to be 360 degrees continuous. Minimum working load (pounds): ______________________________ Minimum tipping load (pounds): ______________________________ Height from ground to platform floor (feet): ______________________________ Working radius from center line of rotation (feet): ______________________________ Lower boom arc of travel (degrees above/below horizontal, highest to lowest): __________________ Upper telescopic boom arc of travel (degrees above/below horizontal, highest to lowest): ___________ Overall height in travel position (feet): ______________________________ Comply Yes/No: _________________ Hydraulic System: The hydraulic system shall be of open-center design which operates at 3,000 PSI and 10 GPM. The system shall have a 10-micron return-line filter, mounted above the hydraulic oil level and inside the pedestal, which can be easily changed without draining the reservoir. There shall be a filter gauge with a color-coded range to monitor the condition of the return line filter for replacement. The 100-mesh suction strainer in the reservoir shall be easily removable for cleaning. There shall be a gate valve located below the reservoir to prevent oil loss when the pump is serviced. The reservoir shall have a magnetic drain plug to attract metal particles from the oil. Comply Yes/No: _________________ Control System: The system shall have a single-stick upper control which consists of a multi-jointed handle that operates all four (4) functions of the control valve. A safety trigger located on the underside of the single stick handle will not allow boom movement until it is depressed. An emergency stop control shall be provided. Upper controls to be centered on wide side of bucket. Individual full-pressure controls located at the turret shall actuate all boom functions. The lower control station shall be equipped with a selector valve to override the upper controls. The hydraulic control valves will be full pressure and full flow. The start/stop system shall be designed so that the lift cannot be operated normally unless the unit power switch is activated, and the truck ignition is in the βonβ position. This will make it difficult for unauthorized individuals to operate the lift when the truck is locked. Start/stop controls shall be located at the upper and lower control stations. Comply Yes/No: _________________ Emergency Lowering: The aerial device shall be equipped with a 12-volt emergency lowering system with switches located at both the lower and upper controls. This system will enable the operator to safely return to the ground should the primary system fail while the aerial lift is elevated. Comply Yes/No: _________________ Platform: The platform shall be a 24-inch (height) x 48-inch (width) x 42-inch (depth) closed two-man fiberglass unit with one step. The platform shall be end mounted with hydraulic leveling. The leveling system shall include a master/slave cylinder arrangement that can be actuated from the upper or lower controls for cleanout or rescue. The unit shall have a hydraulic platform rotator that is operated by a control lever and rotates the platform 180o from one side of the outer/inner boom assembly across the end-hung position to the other side of the outer/inner boom assembly. Two body harness and lanyards shall be provided. The unit shall have the anchors for the lanyards attached to the platform support. Comply Yes/No: _________________