All correspondence must be made through the Vendor Portal. Specifications include, but are not limited to: DESCRIPTION: New current galvanized front side dump/flatbed trailer Tandem axles 16,000# GVWR minimum Suspension, frame, axles, wheels and tires of rated capacity of GVWR 82” wide x 18’ in length – (8’ box length and 10’ deck length) Galvanized dump box to tilt to the curb side with a “top swing” style dump gate and to have a rear of box mounted box gate, full width that is hinged to the street side that will be able to open to the flatbed load area to the inside surface of the street side fender to have a latch to hold the gate in the open position. The dump box shall be lifted (tilted) by a hydraulic cylinder with a stainless steel or aluminum tongue box mounted battery operated hydraulic pump with pendant cable remote with a 120 volt battery charger mounted to charge the lift system battery and solar charger battery maintainer mounted on top lid of dump box. Dump box is to be 82” wide by 8’ long with 24” sides. Box is to have two (2) street side mounted “D” type lift assist rings Flatbed area is to be 82” wide with 2” x 8” treated lumber decking with under floor supports to be on 12” centers Load area to have a railing bar the same height as the fenders and to have equipment tie down stake pockets mounted on the outer frame surfaces on street and curb sides, one in front and three (3) in back of each fender on the outer surfaces of the main bed frame Mud flaps installed behind rear wheels One (1) drop leg jack with adjustable leg and sand shoe of manufacturer recommended rated capacity 3” lunit eye adjustable hitch from 20” to 28” with safety chains and hooks Trailer plug to be “Standard” TPC61M or equivalent. All 12 volt lights to be LED type, flush mounted and to meet FMVSS108. All connections to be soldered and heat shrink covered. All trailer wiring to be connected in a “World American” #WA22040 seven (7) pole junction box or equivalent mounted to the inner street side frame rail just behind the trailer hitch area. Full width fold down tailgate ramp to be expanded metal covered with heavy duty supports installed and to be stowed in the upright position Electric brakes on all wheels with brake shields on all wheel positions with solar charger and breakaway kit Hot dipped galvanized finish on main trailer. All attaching parts to be painted black. Red/white reflective tape installed to meet DOT C2-2 requirements OTHER: Service and parts manual for all trailer and mounted components