All correspondence must be made through the Vendor Portal. Specifications include, but are not limited to: Two (2) 12,000# capacity axles (painted black) minimum, spring suspension, all galvanized wheels with tires of adequate capacity for the GVWR LED lights and reflectors which meet DOT standards 102” wide x 23’ long main deck 5’ long x 102” wide dove tail ramp with two (2) hydraulic lift fold over ramps with spring assist that are 5’ feet long also that will cover the full width of the trailer that have the ability to be folded completely over to provide a flatbed extension to the rear of the trailer or be locked (pinned) in a vertical position. Ramps to have heavy duty inverted angle iron traction area for full width and length of ramp area including trailer main frame ramp area Deck sub frame cross members to be 3” channel on 16” centers with 2” thick rough cut decking 3/16” steel tread plate attached to the bottom side of the ramps so to line up with the main trailer decking when the ramps are laying in the folded up position so to extend the deck back another 5’ rearward Minimum 6” x 6” square torque tube from the center of the center front frame support back to the front of the first axle tied to a heavy cross frame between the two mainframes 2 5/16” square adjustable height goose neck coupler 25,000# minimum with safety chains to be painted black The horizontal portion of the gooseneck hitch area to have a heavy duty expanded metal storage area with a reinforced frame under the expanded metal built into the lower portion of the horizontal hitch framework using the framework of the hitch as the sides of the stowage area and install a rear panel in the rearward portion of the hitch area using as much of the upper hitch area as possible for stowage Ship loose one (1) spare tire and galvanized wheel the same size as the trailer tires 3” wide x 3/8” thick tie down rub rails with stake pockets on 24” centers full length of trailer with no splash deflectors in the wheel areas so not to inhibit the tie down function of the rails Two (2) 12,000# each rated hydraulic tandem lift jacks with sand shoes to be painted black Small six round pin trailer socket plug (Standard #TCP61M or equivalent) Inverted 4” wide steel heavy channels mounted full width and length over the top area of each wheel area supported between the two axles on each side by crossmember and attached to the crossmembers in front and rear of the tires. Top of inverted channels to be flush with the wood deck surface of trailer Aluminum underslung street side mounted hydraulic pump/battery box mounted just in front of the street side front wheels to be watertight with lockable latch and fold down door. Box to include individual control valves for ramp operation and lift jack operation. Minimum 12’ long pendant control cable Electric over hydraulic 12 volt pump with deep cycle 12 volt battery to include a 120 volt battery charger mounted in under slung box Full width toolbox mounted at the top of the vertical hitch between the beams. Box to be mounted on inverted angles on each beam with bolts. The box is to be the same depth of the vertical channeling of the beams. The height of the forward facing side of box to be 16” high with a rearward facing to the load area door angling down to a 12” high side facing rearward to the load area. Lid to have padlock hasps at each end of lid for locking. Box to be constructed with a minimum thickness of 3/16” steel material with drain hole in the bottom floor. Box to be painted black 1/4” thick x 2 1/2” x 2 1/2” steel angle bolted to mounts between the vertical hitch uprights just below toolbox for boomer and tie down chain stowage with a removable locking device to retain boomers and chains in position