Specifications include, but are not limited to: Capacity: One (1) bucket, working load of 300 pounds and tipping load of 450 pounds in all positions, height from ground to bucket floor to be 37 feet when mounted on a truck chassis, working radius from center line of rotation to be 27 feet, overall height in travel position to be 13 feet maximum, lower boom travel to be 0 degrees to +94 degrees, upper boom travel to be -17.5 degrees to +75 degrees, rotation to be 360 degrees continuous. Minimum working load (pounds): ______________________________ Minimum tipping load (pounds): ______________________________ Height from ground to platform floor (feet): ______________________________ Working radius from center line of rotation (feet): ______________________________ Overall height in travel position (feet): ______________________________ Lower boom arc of travel (degrees above/below horizontal, highest to lowest): __________________ Upper telescopic boom arc of travel (degrees above/below horizontal, highest to lowest): ___________ Comply Yes/No: _________________ Hydraulic system: The hydraulic pump shall be engine-mounted, belt-driven. It shall be of sufficient size to operate all functions. The system shall have double-acting hydraulic cylinders to operate the upper and lower booms; all cylinders to be equipped with pilot-operated check valves to hold load in case of system failure; rotation to be driven by hydraulic motor; to be equipped with all lines, hose fittings, valves, filters, and reservoir required to perform the function of the bucket. Comply Yes/No: _________________ Controls: To be equipped with controls that can be operated from the bucket and override controls that can be operated from the ground or truck platform; to have engine start and stop switch located at the bucket, and manual two-speed throttle control