Specifications include, but are not limited to: Working Dimensions • Machine dimensions: appx 163” W X 117” D X 132” H • Spacing Requirements: 261” W X 216” D X 132” H • Max Workload: Appx 7” Diameter X 20” Height • Weight of complete unit: 8000 kg Temp and Pressure • Max operating temperature: 2000°C with graphite furnace installed, 1400°C with Molybdenum furnace installed • Max operating pressure: 205 MPa Part Handling • Max weight of Workload (including weight of load basket): 60 kg for Moly basket, 40 kg for graphite basket • 2 heating zones Controls & Software • Programmable controller (PLC): Allen-Bradley by Rockwell • Supervisory system – HMI system: PC based • Device for Remote Diagnostics Functionality (RDF): Ewon • Backup Power (UPS) time, of control system, at power failure: > 20 min Hardware & Build • A top-loaded pressure vessel with wire-wound cylinder & frame. • HIP system with interchangeable Molybdenum and Graphite furnaces. • HIP system with rapid and controlled cooling to enable high pressure heat treating. • Molybdenum furnace with Molybdenum side and base heater elements for a max operating temperature of 1500 °C and thermocouple plug-in contacts for heating zone and workload temperature measurement. • Graphite furnace with graphite side and base heater elements for a max operating temperature of 2000 °C and thermocouple plug-in contacts for heating zone and workload temperature measurement. • Gas handling system, complete with one compressor and necessary electrical motor, hydraulic pump, valves, sensors and safety devices. • Vacuum pump, valves and sensors. • Closed loop cooling system, complete with pumps, water tank, heat exchanger, valves, necessary flow, pressure sensors and temperature sensors. • Argon reclaim/reuse system to enable capture of argon from HIP cycles.
