Specifications include, but are not limited to: 350 LWB MEDIUM ROOF ADA TRANSIT VEHICLE Page 2 of 24 A. OEM Chassis Specifications 1. Dimensions a. Regular Wheelbase (Measurements are Minimums): i. 147.6” wheelbase ii. 67.6” interior height (Medium Roof – measured at the centerline with the headliner in place) iii. 99.2” minimum exterior height (Medium Roof) iv. 235.5” minimum vehicle length (Medium Roof/LWB) v. 63” minimum interior height at point of entry (measured at the centerline with the head liner in place) vi. 67” minimum interior width (measured at the floor) vii. 130” minimum passenger area length (measured from top of driver’s seat back to rear door) 2. Body & Frame a. Specific areas within the chassis and frame of the Rear Lift ADA Transit Vehicle have been identified by the manufacturer as precautionary drill or weld zones. Vendors responding to this solicitation must follow manufacturer guidelines to prevent void of warranty. Body shall have clean beads of caulking at all joints and seams. 3. Engine a. 3.5L Naturally Aspirated PFDi V6 or approved equivalent i. Minimum 275 HP, 260 lb. ft. Torque ii. Fuel – regular unleaded or E85 b. Engine Block Heater: A 400-watt (minimum) OEM equipment engine heater shall be provided to assist cold weather starting. It shall be mounted in a manner that the wiring will not contact hot engine parts. The exterior plug must have a cover to pre-vent the entry of water. The plug-in must be accessible from outside the vehicle. 4. Transmission / Axle Ratio a. 10-speed automatic with overdrive b. 3.73 axle ratio (3.31 or 3.73 with EcoBoost) c. All-Wheel Drive 5. Gross Vehicle Weight Rating (GVWR) a. 9,000 lbs. GVWR b. 4,130 lbs. front axle capacity c. 5,730 lbs. rear axle capacity 6. Fuel Tank a. Factory standard twenty-five (25) gallons 7. Steering/Brakes a. Power Steering
