Specifications include, but are not limited to: Herbicide Truck Retro Up Fitting; The Contractor must install, calibrate, and test the spray on an ITD supplied existing herbicide application spray truck. The truck is a 2008 International 4 x 2 Model 7400 Work Star, VIN 1HTWCAAR68J689037, with a 35,000 GVW rating, 14,600 lb front axle, 20,000 lb rear axle. The truck chassis is equipped with the existing herbicide application equipment as listed below: One (1) 1300 Gallon Water - Reused; One (1) Steel Platform - Reused; Four (4) Chemical Tanks - Reused; 85 gal Cone Tank; 30 gal Cone Tank; One (1) 85 gal Cone Tank; One (1) 35 gal Rectangle Tank; Hydraulic Installation: 1. All high pressure hydraulic hoses will be a minimum 2 braid and a minimum of 3000 PSI.; 2. All hoses must be routed in a manner to minimize rub points and bends. Hoses that will rub against metal during the operation of the Sprayer must be wrapped with jacketed flex mesh for protection.; 3. All hoses must be routed to protect them from heat sources and enclosed whenever possible to protect them from damage.; 4. Teflon tape must not be used in the hydraulic system.; 5. Hydraulic hoses must not be secured to any factory-installed chassis wiring, cables, hoses, or lines.; Electrical Installation: 1. All installed electrical cabling must be of adequate size to handle the anticipated loads of all electrical components. All cabling must be uninterrupted and complete with no splices.; 2. All electrical cabling must be color-coded.; 3. All cable terminal ends must be: Crimped, soldered to the cables and sealed with polyolefin heat shrink tubing, or weatherproof connectors. Scotch-Loc fasteners and/or crimp butt connectors are NOT acceptable for any connection.; 4. All electrical cable connections must be protected with dielectric grease.; 5. All exposed electrical cabling must be enclosed in a protective loom, chemical resistant conduit or loom, including Controller Area Network (CAN) bus communication cables and be grommet protected when passing through metal or sharp surfaces.
