Specifications include, but are not limited to: 6-Wheel Cab & Chassis with Pusher Axle Specifications o Must be a new unit either model year 2022 or 2023 o Heavy duty 6-wheel cab and chassis with a GVW of no less than 33,000 lbs. o Truck to be painted white o Dura bright aluminum wheel rims. o Rear wheels to be spaced at a minimum of 2”. o Rear axle to be 23,000 lb. minimum. o 20,000 lb. minimum pusher axle with tires and Dura bright rims. o Pusher tires shall be 14-ply 255/70/R22.5 o Rear suspension to be air ride and to be rated for 26,000 lbs. minimum. o Front axle to be rated for 10,000 lb. minimum. o Set back axle on front to facilitate tighter turning radius. o Two factory tow hooks to be installed on front of truck o Front shocks included. o Conventional Day Cab wheelbase to be a minimum of 138” and shall meet the packer assembly needs. o Chassis must accommodate the packer unit and all necessary packer support items. o 6-cylinder Detroit Diesel Engine o Glow Plugs o Wet sleeve o Turbocharged o Minimum 350 HP o Magnetic oil drain plug o All filters are to be spin-on type (except air filters) o Compression brake included o Cooling fan shall have a thermo-viscous clutch. o The exhaust system shall be chrome, vertically mounted, extend above the cab and shall include the safety guard. Horizontal runs of the exhaust system shall not sit above the frame. o Allison 3000-series automatic 6-speed transmission with PTO output, magnetic oil drain plug, oil cooler system and equipped with Shift Energy Management Low Range Torque Protection (SEM/LRTP). Auto-neutral when maxi-brakes are applied. o Dual axle air brakes with ABS, Meritor disc brakes on all wheels, front, rear, and pusher axle. o Minimum 60 gallon fuel tank with step(s) mounted on the driver’s side of the truck and shall extend beyond the rear of the cab to provide more spacing behind front wheel. o Shut off valve shall be mounted at the fuel outlet. o One-piece heavy duty reinforced heat treated high tensile steel straight channel frame with minimum 110,000 PSI yield strength. This frame must be supplied from the factory, not retrofitted at the dealer. o 3-piece wrap around front bumper. o Tilt steering wheel. o Passenger side running board with non-skid grating and three equally spaced steps for ease of entry. o Rear axle to have magnetic drain plug o Differential lock o Drive line shall be heavy duty and factory balanced. o Heavy duty power steering. o Tires shall be as follows: o Front: 11R x 22.5 14-ply tubeless all-season standard radial o Rear: 11R x 22.5 16-ply tubeless traction mud & snow rated o Spare: one (1) each rear tire and front/pusher tire mounted on hubs and balanced o Wheel hubs to be 10-bolt cast iron on front and rear. o Air dryer with heater o Air drain valves shall be equipped with remote pull cables o 12-volt electrical system with a minimum 160-amp charging system/alternator. o Two (2) each 12-volt maintenance free batteries. o Master battery disconnect switch mounted inside the cab on driver’s side seat on floor. o Backup lights on the packer unit. o Factory front fog lights.