Specifications include, but are not limited to: Existing Equipment Garage Demolish and remove existing vinyl siding, metal trim and shingle roofing off of existing structure. Modify existing stud framing and sheathing, as required for new 12'-0" x 7'-0" overhead door and for (3) new 3'-0" x 7'-0" door openings as indicated on plans. Pour new footing, lay foundation and pour new floor slab for connector to adjoining Maintenance Shop. Top of floor slab to match Equipment Garage. Connector to be constructed of 2x4 wood stud framing with 5/8" "zip board" sheathing and roof decking. Connector roof shall tie into gable end wall condition of new maintenance shop and be overbuilt on the existing Equipment Garage roof. Finish exterior of structure with new vinyl siding, metal fascia trim and shingle roof to match Maintenance Shop. Install new gutters and down spouts.; Maintenance Garage - Demolish and remove existing 4" CMU starter/base block and anchor bolts around perimeter of existing 24'-0" x 30'-0" concrete floor slab. Existing floor slab to remain. Pour new footing, foundation and floor slab along east edge of slab for new 12'-0" x 30'-0" addition. New concrete slab finished elevation to match existing. Lay new 6" CMU sill block around perimeter of original slab and epoxy in new wall anchors. New Shop to be constructed of 2x6 wood stud framing with 5/8" "zip board" sheathing and pre-engineered wood trusses at 24"o.c. covered with 5/8" "zip board" decking. Finish exterior of structure with new vinyl siding, metal fascia trim and shingle to roofing to match Maintenance Shop. Install new gutter and down spouts. Modify existing concrete sidewalk so as to allow accessibility per Building Code.; Lawn & Garden Storage - Demolish and remove all components of existing 24'-0" x 32'-0" Equipment Shed in their entirety. (Siding, framing, concrete slab, etc.) Pour concrete pier footings and floor slab for new 24'-0" x 32'-0" Pole Barn framed structure. Equipment Shed to be 20'-0" x 24'-0" and tool storage to be 12'-0" x 24'-0". Each area to be accessible with a 10'-0" x 10'-0" overhead door located on gable ends of structure as well as a 3'-0" x 7'-0" man door located along the southern wall. Finish exterior of structure with exposed fastener metal siding and roofing.