Specifications include, but are not limited to: NEMA P-size traffic signal cabinet for spare (or equivalent) Brushed aluminum finish Signal operation: assume it will be an 8 phase intersection with FYA (mode G) with pedestrian signals NEMA TS-2 type 1 cabinet with; 16 load switch back panel, led interior lighting, six SDLC cables, TS-2 detector rack with 16 vehicle detector inputs and 4 preemption inputs, cabinet/electrical prints (1 set paper & PC file) Include 10 pin to 55 pin adapter for TS-2 type 2 controller “A” connector Include three BIU’s and one TS-2 cabinet power supply with each cabinet Transfer switch: Reliance C30A1L, or approved equal, transfer switch installed and prewired on signal cabinet, right side near top. Include one 15” cabinet riser and bolt kit with each cabinet (Response required) Quantity: 2 UOM: EA; Tesco service/BBS cabinet- NO SUBSTITUTIONS- with the following specifications: Tesco 27-22 BBS Metered service pedestal & battery backup system Provide metered disconnect for traffic signal & street lighting. Provide two 2-pole lighting circuits, controlled by photocell. GFCI service outlet mounted in dead front panel. Fabrication from 1/8-inch anodized or natural brushed aluminum. Small and low profile with no exposed fasteners. Durable all welded construction. Vandal proof doors with hasp stress rated to 2000 lbs. Factory wired and tested before shipment. UL approved copper cable busing and control wiring. Meets EUSERC requirements. Metered circuits up to 100 Amps. Dual Cabinets external dimensions: 20.5 inches wide x 50 inches high x 19.25 inches deep, excluding door handles. (For replacement use, needs to be an exact fit) (Response required) Quantity: 1 UOM: EA; Polara EN2 cabinet wire harness- NO SUBSTITUTIONS- with these specifications Polara CCU2ENHK Shipped loose, to be field installed by city staff With power cable for CCU (Response required) Quantity: 2 UOM: EA