Specifications include, but are not limited to: BODY STRUCTURE: Standard van body shall meet all stated specifications. The vehicle shall be reinforced such that the structural of the basic van is not degraded.; Vehicles shall meet all applicable requirements of the Americans with Disabilities Act (ADA As set forth in CFR 37 and 38, issued September 6, 1991, with respect to the body.; OEM CHASSIS FRAME AND BODY; Dodge Ram ProMaster 3500 extended body179.8” Wheelbase Wagon with Single Rear Wheels or Equivalent.; Deluxe Interior and Exterior trim.; DOORS: A Bus Style Entry Doorway shall be included rear of the Curbside B Pillar.; The Minimum Clear Entry Width Shall be 32”.; There shall be no steps to enter the vehicle and the floor shall be a maximum of 11” from the ground.; Stainless Steel Powder Coated yellow Assist Handrails on the Interior Left or Right of the Doorway Structure shall be Included; An L.E.D. Light that automatically illuminates when the Doorway is opened shall be Included.; WHEELCHAIR RAMP: An electric operated wheel chair ramp shall be mounted in the passenger entrance door opening and shall be either in-floor or swing away and stow to allow ambulatory passenger ingress and egress. Ramp shall have a minimum clear opening of 32” and have a rated capacity of at least 800 lbs.; DOOR LOCKS: All doors shall be equipped with a lock.; DRIVER’S DOOR AND CO-PILOT’S DOOR: Must have Power windows and Power door locks; RUNNING BOARDS: Extra Heavy-duty Running Boards for Driver door and Co- Pilot’s door.; HANDRAIL: Handrails (left and right) of the front passenger door shall be provided. Cross-sectional diameter of handrail shall be between 1 ¼” and 1½”.; Entrance handrails shall be provided on inside of both entrance doors for use by passengers entering and exiting; All handrails must be Stainless Steel powder coated yellow that will not rattle or Flex and mounting bolts shall be bolted into Structural steel.; INTERIOR: Interior wall and ceiling paneling in passenger compartment shall be molded ABS plastic.; The Drivers Side Ejection Mitigation Air Bag Shall be Retained.; All interior panels, materials, and treatments shall meet all FMVSS 302 requirements.; FLOOR ASSEMBLY: The lowered subfloor shall be of a composite that is guaranteed not to rot. The use of plywood for a subfloor will not be accepted.; The floor covering shall be wall-to-wall hard fire-resistant slip- resistant, transit quality flooring securely bonded to the plate steel floor with waterproof adhesive.; Flooring Color shall coordinate with interior colors of OEM van.; SLIP-RESISTANT FLOOR COVERING: Floor covering shall be slip resistant vinyl flooring, constructed with aluminum oxide, silicon carbide and optional PVC chip blended throughout a high quality vinyl wear surface.; Top coating is not acceptable.; Backing to be polyester/cellulose material with fiberglass fiber reinforced center scrim for additional durability.; Must be Altro Transflor Figura – Pinwheel with a minimum thickness of 2.0 millimeters or equivalent; Color to be selected from current Altro color range.; The whole floor will be a uniform thickness throughout the vehicle, eliminating the need for ribbed surfaces, while exceeding the ADA minimum slip resistance standard rating of .06 static coefficient of friction under dry or wet conditions.
