Specifications include, but are not limited to: The Division is requesting interested vendors submit bids to address the following modifications: Qty Description 1 HVAC unit (cargo area) 1 Power inverter 1 ¾” plywood subfloor 1 Floor finishes and trim 1 Foam board or fiberglass insulation 1 3/8” Plywood liner or ceiling 1 ½” Plywood liner on walls 1 Commercial grade carpet on all walls and bench seating 1 Grab rails along rear cargo area 1 Jump seat on front partition wall 1 Partition wall behind the driver and passenger seat with an opening to access the driver’s compartment 1 Two monitors and a foldaway desk on the partition wall 1 Radio charging bank 1 Bench seating along both passenger and driver side walls. To include a storage compartment under the bench. 1 Interior lighting system 1 Steps for the rear and side doors 1 Contractor style isolator for auxiliary chassis batteries. 1 Auxiliary battery 1 Emergency lighting and supporting switches 1 20 AMP, 125 VAC shoreline inlet Storage compartment in the rear compartment (facing rear cargo doors). Measurements consistent with the interior compartment, depth of compartment not to exceed 3’. 1 Mounts, hardware, and whiteboard for exterior of vehicle (Briefing board/ NIMS compliant) 1 Panoramic exterior camera system
