Specifications include, but are not limited to: E. Boat – General Specifications The following Specifications are the minimum that IDFG is willing to accept. Boat must meet all United States Coast Guard (USCG) standards. 1. Boat – welded aluminum jet boat, twenty (20) ft., not including swim deck and pump guard. 2. Bottom width of seventy eight (78) in., one quarter (0.250) in. thick 5086 aluminum, 0.375 in. 6061 aluminum welded in center section, thirty two (32 in. wide by one hundred twenty (120) in. long. 3. Delta pad - bent into bottom for pump intake transition. Delta pad must be a minimum of twelve (12) ft. long. Two (2) lift strakes on each side placed for maximum performance. Ten (10°) degree “V”, sixteen (16°) degree reverse chine bent into bottom, four (4) in. wide in the rear tapered forward to two (2) in. 4. Beam – one hundred two (102) in. 5. Sides – thirty six (36) in. tall (chine to gunwale), one-eighth (0.125) in. thick 5086 aluminum, must have a minimum of two (2) equally spaced corrugations. Gunwales must be bent continuous from side, seven (7) in. wide. 6. Transom – 0.190 in. thick, 5086 aluminum with corrugation or bend across transom above pump and below swim deck. 7. Bow deck - must be made of one-eighth (0.125) in. thick 5052 (or stronger) aluminum, diamond deck. Bow deck must consist of three (3) pieces with the center section bent on the sides to form a raised section. The two (2) outside sections must be braced ten (10) in. on center. Profile of the bow deck must have a slight positive crown. 8. Bow deck length - bow deck must be a maximum of forty eight (48) in. from tip of bow to the front of windshield. Bow deck must include an anchor box with latching lid, large enough to accommodate a large river anchor. F. Hull Construction 1. Sheet aluminum must be 5086 alloy unless otherwise specified. 2. Extruded aluminum must be 6061 alloy. 3. Bottom of boat must be reinforced on the inside with a minimum of eight (8) stringers or stiffeners. 4. Formed stringers must three-sixteenth (0.1875) in. 5086 (or heavier duty material). 5. Extruded stringers must be a minimum of two (2) in. x one-quarter (0.25) in. channel. 6. Bottom must extend beyond transom by a minimum of two (2) in. 7. Chines must be protected by one and one-half (1.50) in. x one and one-half (1.50) in. x three-sixteenth (0.1875) in. angle. 8. Side trays must be full length of sides to dash area. 9. Floors and decking must be aluminum. G. Windshield 1. Thirty three (33) in. tall, fifty five (55°) degree slope, must have walk through door in center twenty two (22) in. minimum width. 2. Side windows must be tempered glass. 3. Aluminum 5052 – 5086.