Specifications include, but are not limited to: Bulk Enhanced Lime Ca(OH)2: 3.2.1.1 The Product shall meet the minimum Typical Analysis of Enhanced Lime: Chemical Properties: Total Ca(HO)2 95.5% or greater; Available Ca(HO)2 91.7% or greater; Magnesium Oxide (MgO) 0.9% or less; Silica (SiO2) 1.1% or less; Ferric Oxide (Fe2 So3) 0.9% or less; Alumina (Al2O3) 0.4% or less; Moisture (H2O) 0.9% or less; Physical Properties: Pore Volume in cm3/g 0.13 cm3/g or less; Volume Mean Diameter/Particle Size Microns (um) 7.8 microns or less; Passing 325 Mesh 93% or more; 3.2.1.2 The Vendor shall be responsible for acquisition and utilization of all reasonable and necessary equipment, licenses, permits and specialized equipment.; 3.2.1.3 Quantity and scheduling delivery of the Product will be directed by a WVDEP-DLR Representative.; 3.2.1.4 The Vendor shall be responsible for bulk deliveries of Enhanced Lime in full loads of a minimum of ten tons to a maximum of twenty-five tons for treatment sites in West Virginia as designated by WVDEP-DLR Representative. Loads may be split among sites.; 3.2.1.5 The bulk lime shall be mechanically off loaded into water treatment lime storage silos. Silos shall be filled with a Pneumatic Tanker.; 3.2.1.6 The Vendor shall be responsible for clearing any clogs that occur during the filling of the silos from the delivery truck to the point of connection on the silo.; 3.2.1.7 The WVDEP-DLR shall not be responsible for any terms of any subcontract the primary vendor may enter into to perform the duties of this contract.; 3.2.1.8 The Vendor has sole responsibility for carrying out the terms of this contract.; 3.2.1.9 The Vendor shall supply all transportation, labor and supervision necessary to provide Enhanced Lime to designated WVDEP-DLR Treatment sites.; 3.2.1.10 The Vendor shall be paid based on unit price, which must include all transportation costs, labor costs, recycling costs and any other fees necessary to perform under this contract.; 3.2.1.11 DEP will if necessary, confirm with the vendor that the product being provided meets the mandatory specifications by requesting up to date data sheets from an authorized lab upon request. These data sheets must show the product meets or exceeds the chemical properties listed in 3.2.1.1
