Specifications include, but are not limited to: Boat hull – seventeen (17) ft. ten (10) in. x seventy six (76) in. (bottom width), aluminum with center console.; Hull bottom – must have four (4) corrugations, two (2) on each side of the tunnel.; Tunnel hull – tunnels must be fourteen and one-half (14.5) in., must be one and a half (1.5) in. deep with smooth transition from hull bottom to bottom of tunnel.; Bottom thickness of aluminum alloy 5052 (0.125 in.) with one-quarter (0.25) in. thickness down the center thirteen (13) in. of hull.; Welding – must be marine grade and must adhere to all American Welding Society (AWS) standards.; Dry weight – must not exceed one thousand two hundred (1,200) lbs.; Deadrise – must be nine (9) degrees.; Bow design – must be rectangular with diamond plate bow cap.; Beam – ninety eight and one-half (98.5) in.; Centerline length – seventeen (17) ft. ten (10) in.; Side thickness – one-eighth (0.125) in.; Side height – twenty nine (29) in.; Transom height – must be capable of accommodating a two hundred (200) HP, 4-stroke jet outboard motor at five thousand (5,000) ft. elevation.; Must have a five and one-half (5.5) in. flat gunnel, non-skid and two (2) in. by three (3) in. rectangular tube welded to the edge.; Flooring – must be wood-free, composite, high density, coated with herculine/line-x or equal.; Must have an extended bottom trim plate located off the transom.; Fuel tank – must be aluminum, built-in, located under the floor, baffled. Must have a minimum fuel capacity of thirty two (32) gallons.; Must have a full width, self-bailing transom shelf (splash well).; Must have welded bow and stern eyes.; Must have full length tackle/gear trays welded along the inside of hull.; Must have a gas/water separator.; Must have recessed bow left/right navigation lights.; Must have recessed light bar (headlight) in bow, twenty one and one-half (21.5) in., must be LED, light switches must be located on the console.; Must have LED cabin lights.; Bilge pump – must be capable of pumping a minimum of one thousand two hundred fifty (1,250) GPH.; Must have dash mounted hydraulic steering system.; Must have two (2) transom swim platforms, aluminum, located on each side of the outboard.; Must have a transom-mounted transducer bracket.
