Specifications include, but are not limited to: 1. CAPACITY A. The body shall have a minimum of 40 cu yds ____ ____ ______________________________ 2. BODY DIMENSIONS A. Maximum overall body width not to exceed 101-1/2” ____ ____ ______________________________ B. Maximum overall length and height (with tailgate in locked position and arms & forks in down position) above the chassis frame not to exceed: a. Capacity 40 Cu. Yd. ____ ____ ______________________________ b. OAL Length 457” ____ ____ ______________________________ c. Height 110 ¾ ____ ____ ______________________________ d. WB: 208”-210” ____ ____ ______________________________ 3. BODY CONSTRUCTION A. The body sides shall be constructed of 1/8” AR450 formed to a radius for added strength ____ _____ ______________________________ B. The body roof shall be constructed of 10 ga 80,000 psi yield steel ____ _____ ______________________________ C. The body floor shall be curved and made of 3/16” AR235 ____ _____ ______________________________ D. The floor longitudinal shall be 2” x 6” x 1/4” structural tube ____ _____ ______________________________ 4. HOPPER A. The hopper shall have a minimum capacity of 12 cu yds ____ _____ ______________________________ B. The hopper floor shall be constructed of minimum 1/4” AR450 stee C. The hopper sides shall be constructed of onepiece wall minimum AR450 steel formed to a radius for additional strength. Straight hopper sides are not acceptable ____ _____ ______________________________ D. The hopper front shall be enclosed with expanded metal for viewing behind the packer blade and to prevent trash from blowing out ____ _____ ______________________________ E. The hopper shall be lined with six (6) 1/4” wear strips with a minimum of AR450 to match the wear strips on the packer panel. Plow steel wear strips are not acceptable ____ _____ ______________________________ F. There shall be a hydraulic sliding hopper cover constructed of 14 ga A569 steel and reinforced with 1” x 2” tube ____ _____ ______________________________ G. The hopper cover shall be powered by a one (1) double acting hydraulic cylinder ____ _____ ______________________________ H. The hopper cover shall open automatically when raising the lift arms ____ _____ ______________________________ I. There shall be a SPDT (Single Pull Double Throw) electrical switch in the cab to manually close the hopper cover ____ _____ ______________________________ J. There shall be a sliding side access door with a PTO interlock and shall be a minimum of 31” x 31” ____ ____ ______________________________ K. Minimum of 145-gallon rear body sump ____ ____ ______________________________ 5. PACKING MECHANISM A. The packing panel face sheet shall be constructed of 3/16” AR450 Steel ____ _____ ______________________________ B. The packing panel shall slide in a track constructed of 1/4” formed 50K channel and lined on all three sides with AR450 wear strips ____ ____ ______________________________ C. The packing panel shall be activated by two (2) 6-12” stroke four stage telescopic hydraulic cylinders with U-cup seal design and rod scrapers ____ ____ ______________________________ D. The panel shall have a pack cycle of 25-27 seconds E. The packing panel shall include adjustable side scraper wings
