Specifications include, but are not limited to: The University of Louisville Procurement Services, on behalf of Physical Plant, will receive base bid proposals for replacement of the lighting system to new LED Fixtures and Hardware provided by University of Louisville and will be installed on 30’ poles at various parking lots on campus as shown on the drawing details prepared by the University of Louisville (Appendix A). Please also see the installation instructions provided by the manufacturer (Appendix B). Provide any miscellaneous material, wire, wire nuts, tape, labor, supervision, inspections, testing. The Contractor will remove and dispose of existing light fixtures on 30’ poles. After area is complete Physical Plant will inspect after dark and contractor to adjust if needed to complete as described and in accordance with the drawings prepared by the University of Louisville.; MOUNTING THE UNIVERSAL ARM ON THE FIXTURE: 1. Remove the Arm Cover from the Arm by loosening Arm Cover Screws as shown in Fig. 1.; 2. Feed wires from fixture into Arm.; 3. Line up Arm and fixture. Tighten screws inside the Arm and tighten securely to housing.; 4. Replace the Arm Cover and secure with Screws as shown in Fig. 2.; Square Pole Mount: 1. Place the Bolster Plate inside the Pole as shown in Fig. 3.; 2. Remove the Round Pole Adaptor Plate.; 3. Fix Arm to Square Pole with Bolt.; 4. Open the Arm Cover and pull the wires into the junction box.; 5. Feed supply wires from the Pole to connect to the Arm. Make appropriate wire connections per NEC in an approved enclosure (Fig. 7).; 6. Use bolts to tighten to the Pole.; Round Pole Mount: 1. Place the Bolster Plate inside the Pole as shown in Fig. 3.; 2. Fix Arm to Round Pole with Bolt.; 3. Open the Arm Cover and pull the wires into the junction box.; 4. Feed supply wires from the Pole to connect to the Arm. Make appropriate wire connections per NEC in an approved enclosure (Fig. 7).; 5. Use bolts to tighten to the Pole.