Specifications include, but are not limited to: 2.1 Vendor shall complete the following work in Area #1: • Build new wall approximately 13'10" long. • Add new door, 3'0" on south corner as close to wall as possible with door still opening with hardware at a minimum of 90 degrees. • Finish, paint, and cove base to match existing décor and aesthetics. • Re-work ceiling grid and flooring as appropriate for complete finish. 2.2 Vendor shall complete the following work in Area #2: • Build new wall approximately 13' long. • Add new door, 3'0" on northwest corner as close to wall as possible with door still opening with hardware at a minimum of 90 degrees. • Finish, paint, and cove base to match existing décor and aesthetics. • Re-work ceiling grid and flooring as appropriate for complete finish. • Add new electrical outlet and data run (2 separate CAT6 cables to a dual outlet port.) • Lower 3 electrical outlets (existing) and one data port (existing) to standard height from floor. • Carefully remove all cabinetry and countertops in this area to be repurposed in copier area. • Patch walls and carpeting as necessary from cabinet removal and interior wall removal. • Remove interior separator wall and leave out of new office design. 2.3 Vendor shall complete the following work in Area #3: • Add drywall cover (approximately 2 1/4" thick finished) over existing door and window in southwest corner of office. Please make this slightly wider than the door/window combination and full height. Remove door operating hardware and plate off (door will stay in place). • Finish, paint, and cove base to match existing décor and aesthetics. • Re-work ceiling grid and flooring as appropriate for complete finish. • Move existing light switch for room from southwest corner of office to east center wall proper distance from door/window combination remaining active. • Add two new electrical outlets and add 2 data runs (2 separate CAT6 cables to a dual outlet port).