Specifications include, but are not limited to: Removal of existing shingles, felt, drip edge, flashing, chimney base flashing, ridge vent shingles, and pipe boot with metal base.; Carefully remove shingles, any rotten or deteriorated roof decking, all felt, nails, vents, drip edge, jacks and any rotten or deteriorated building materials where necessary and applicable to this project. Do not damage any substrates or adjacent surfaces, if damaging occurs it shall be repaired or replaced to the satisfaction of the Project Inspector at no additional cost to the State. Contractor will be responsible for any required notifications, inspections, permits, labor, materials, disposal, transport, etc. to complete this project.; The contractor shall completely remove ALL existing shingles, nails, flashing, etc., demolished as a result of this project, from the property and dispose of in a manner that meets ALL codes and regulations regarding disposal of such. Use tarps, as necessary, and utilize good methods to insure that NO existing old nails are lost on the property. Protect all work sites (where current work is being performed) from public access at all times during the course of this project.; Contractor must provide a dumpster specifically for use during this project.; Replacing of rotting or deteriorated wood; Replacing any rotten wood overhang.; Replacing any rotten or deteriorated roof decking.; Replacement wood material should be pressure treated.; Installation of replacement felt, shingles, drip edge, flashing, chimney base flashing, ridge vent shingles, and pipe boot with metal base.
