Specifications include, but are not limited to: 3.1.Quantity twenty (20) shipped to: 515 Rte 100 Killington VT 05751; 3.2.Quantity seventy (70) shipped to: 1477 Button Bay Rd Vergennes VT 05491; 3.3.Quantity ten (10) shipped to Knight Point Rd North Hero VT 05474; 3.4.Quantity forty five (45) shipped to: 1636 Rte 232 Marshfield VT 05658; 3.4.1.Steel Camp Fire Ring; 3.4.2.Rolled from a 3/16 inch thick steel plate with an integral formed 1 inch wide flange around the top edge.; 3.4.3.9 inches tall, 30 inch diameter.; 3.4.4. Draft holes provided near base of ring for fire ventilation.; 3.4.5.Approximately 270 square inches cooking grate is infinitely adjustable vertically from below the top of the fire ring to 7-3/4 inch higher. Built using minimum ½ inch diameter steel grate and support bars.; 3.4.6.The friction mechanisms which hold the cooking grate in position shall be constructed with material of equal or greater dimension or strength than the supporting bars.; 3.4.7. Friction or arrest mechanisms built of plate steel that can warp or bend shall not be acceptable. Bidders will need to provide technical drawings of mechanisms to be considered if they do not fit the above standard.; 3.4.8. Handles are turned outside of the fire ring, away from the fire. The handle grips are stay-cool coiled steel bar.; 3.4.9. The cooking grate can be lifted over and out of the campfire ring but remains permanently attached and engaged with the support hardware.; 3.4.10. Anchored by the three removal-resistant steel spade anchors spaced equally welded to the ring. ; 4. ADA Compliant Camp Fire Ring - Bidders shall provide pricing on Fire Rings to meet the following specifications: 4.1.Quantity six (6) shipped to 515 Rte 100 Killington VT 05751; 4.2.Quantity five (5) shipped to 1477 Button Bay Rd Vergennes VT 05491; 4.3.Quantity eight (8) shipped to 31 Knight Point Rd North Hero VT 05474; 4.3.1.Double Wall ring Construction; 4.3.2.Constructed of 3/16 inch thick steel; 4.3.3.Drain/Draft holes located near bottom of outer ring and at lower burn area of inner ring.; 4.3.4.300 square inch four position adjustable grate constructed of ½ inch diameter A36 steel on 1 1/8 inch centers.; 4.3.5.Black heat resistant paint or powdercoat.; 4.3.6.Three spade anchors either permanently affixed or designed to be tamper resistant when ring is installed; 4.3.7.Jamestown model 11245-2, Pilot Rock LDW36/18/AL or approved equivalent
