Specifications include, but are not limited to: Bar Tacker, Juki 1900S-HS or equal Bar Tacker must be new. Bar Tacker must have a minimum speed of 3,200 rpm. Bar Tacker must have thread trimmer, auto foot lift, and needle thread grasping mechanism. Bar Tacker sewing area must be a minimum length of 30mm and width of 40mm. Bar Tacker must have a foot lift maximum of 17mm. Bar Tacker must have a direct drive head/AC Servo Motor, 220 volt, with 60hz light. Bar Tacker needle must be 135x17 (standard Nm110). Bar Tacker must be complete with table, equipped with a thread tree and a LED light. Bar Tacker must be mounted to the table and sewn off with a sample under presser foot. Bar Tacker must have a 100% replacement availability of parts at time of purchase and to extend a minimum of 5 years. Bar Tacker must be equipped with a starline busway tap box (0B50-30-4-1F) feedrail plug, 30 amp, 600 volt, attached to a 25 foot power cord.