Specifications include, but are not limited to: Tree Quality Selection Criteria: 1. The best trees of each species will be retained as leave trees in all units. Indicators of desirable trees are: straight stems, small branch diameter, good crown coloration, good crown form, good crown ratios (> 45%), freedom from insects, diseases, and physical and mechanical damages, vigorous annual growth as indicated by long terminal leader. 2. Western white pine can be found throughout the units. Healthy western white pine shall be thinned around (including trees < 3’) to an 8’ spacing. The intent is to remove vegetation and moisture below western white pine to reduce the chance of blister rust. Thinning to a tighter spacing next to western white pine will keep a desired stocking density in the event of western white pine tree mortality. 3. These indicators of undesirable trees shall determine the trees to be cut; slight defects may be acceptable for leave tree if it is the best selection within a competitive group. Indicators of undesirable trees are: multiple tops, poor crown ratios (< 45%), poor crown form and coloration, crook or sweep in boles, dead or broken tops, large branch diameter, presence of insects, diseases, or physical or mechanical damages, suppression, poor annual growth as indicated by short terminal leader D. Felling Requirements 1. Cut trees shall be completely severed from the stump. No hang-up "straps" will be permitted. 2. All felled trees shall be severed below the lowest live limb. The maximum stump height shall be 6 inches above ground level, as measured on the uphill side of the tree. 3. Cut trees shall be felled parallel to each other and not criss-crossed or jack-strawed. 4. Cut trees shall be felled away from unit boundaries into the units, roads, maintained trails, wildlife trails, fence lines, established land corners, and streams. Any trees felled on such areas shall be removed. Old roads that are closed can have cut trees fell across them. This will be on a case by case basis. 5. Dead standing trees shall not be cut. 6. Bearing, section-line, or trail-blazed trees shall not be cut. Unit boundary trees with unit flagging can be cut if determined to be excess. 7. Snow damaged, bent over trees will be cut if they are not dead. 8. Cottonwood, birch and aspen trees and other hard woods shall not be considered as crop trees. All cottonwood, birch and aspen trees will be felled, regardless of DBH, if they are within 10 feet of a desired crop tree. E. Slash Requirements 1. Thinning slash shall be confined within unit boundaries 2. Thinning slash shall be removed from all roads, adjacent cut-and-fill slopes, and ditches. 3. Thinning slash shall be bucked and limbed to within 18-inches of the ground. 4. Thinning slash shall be removed from all ephemeral and intermittent stream channels and wet areas that carry seasonal water.
