Specifications include, but are not limited to: It is the intent of these specifications to describe the layout, furnishing and desires of the Purchaser. The vendor is responsible to ensure a complete ambulance equipped as required by KKK-A-1822F or as specified. It is the intent of the purchaser to conform to NFPA 1917 recommendations when possible. The primary objective of these specifications is to obtain the most acceptable ambulance for service in the Lebanon Fire Department. These specifications do not cover specific requirements as to the type of construction and tests to which the ambulance must conform. However, where specified, certain details such as finish, material preferences, and equipment, the successful bidder must conform, or in writing detail the exception. The design of the ambulance must embody the latest approved automotive design practices. The workmanship must be of the highest quality in its respective field. Special consideration shall be given to service access to areas needing periodic maintenance and ease of operation. Construction must be heavy-duty and ample safety factors must be provided to carry loads as specified. The construction method employed will be in such a manner as to allow ready removal of any component for service or repair. The ambulance shall conform to the KKK-A-1822F, in its most recent edition, unless otherwise specified in this document. Only the specified support equipment listed in these specifications shall be provided. The ambulance shall further conform to all Federal Motor Vehicle Safety Standards. No exception. CHASSIS • Type I shall be a Cab-Chassis with modular ambulance body, increased GVWR, storage, and payload. • Chassis will be a Ford F-550 4X4 model year 2022 or newer. Diesel engine. XLT Trim level will be minimum. • The cab will have arm rests for the driver and passenger • The front bumper should be an aluminum “heavy duty” bumper with as much of the forward facing surface as possible covered in red and yellow 6” chevrons. All other metal will be diamond-plate. There will be a frame mounted extra duty 2-inch receiver hitch mounted in this bumper, and 2 additional recovery points. • Whelen 200W siren with 2 speakers • Front and rear mud flaps • IDP front stabilizer • Electric remote control • Heated side view mirrors • Engine hour meter • OEM AM/FM radio