Specifications include, but are not limited to: In-line testing of 3” or greater water meters. Test each meter, indicated by a check mark on the attached list, to determine accuracy and general condition. If meter test conforms to accuracy standards of NEWWA and AWWA for repaired meters, no further work shall be performed, and only the test charge shall be made. However, condition of the meter will not be warranted, since no inspection has been made of the working parts. If the meter tests to accuracy standards of the NEWWA and AWWA, but the City specifies that the meter is to be examined, a test, repair and calibration charge will be made in addition to the test charge. If the initial meter test does not conform to accuracy standards of the NEWWA and AWWA for repaired meters, the meter shall be repaired and recalibrated, and a total charge will be made. All meters shall be tested before and after repairs. Any work not specifically mentioned which is needed to make the repair complete within the intent of this specification shall be performed.