Specifications include, but are not limited to: This specification describes the State of New Hampshire Department of Transportation’s requirement for a heavy duty tag along trailer, minimum 10 Ton payload capacity, beaver tail deck and folding ramps. Built to Truck Trailer Manufacturer (TTMA) Guidelines. Trailer Payload Capacity: Minimum 19,280 LBS. Frame: Minimum Full 12” Channel or I-Beam Front of Drawbar to Rear of Trailer. Cross Members: Full “I” Beam or “C” Channel ONLY (Non Boxed) and fully welded all the way around at each contact point(s) to prevent salt/calcium intrusion and corrosion between metals. Headboard: 8” Full Width Headboard. Deck Length including beaver: 25’ Deck Height: 36” max Beavertail Cleated Beavertail with Raised Wood Center. Ramps: Cleated Ladder Ramps, Adjustable, Dual Spring Assist with Safety Chains or Flat Bar with Safety Pin. Axles: Dual, Dexter minimum 24,000 Capacity, Oil Bath Bearings, with Hub-O-Meter, aftermarket stemco meter is acceptable. Suspension: Spring Type Tires/ Wheels: Nine (9) minimum E rated /10 ply Highway Tread. Hub Piloted. Spare Tire and Wheel to Match, Mounted in Carrier attached to tongue. Brakes: Electric/Self Adjusting W/Breakaway 12-volt battery. Tongue: Tool Tray with Lockable Lid, 12,000 lb. (Static Load) Heavy Duty Screw Type with Drop Foot Landing Gear, Heavy Duty Safety Chains with Slip Hooks with safety latch, Registration Holder Hitch: 3” Forged Eye, Adjustable
