Specifications include, but are not limited to: All Birch, Beech, Striped Maple, and Pin Cherry between 1” and 10” diameter at stump height must be felled on all projects. In addition, all Red Maple between 1” and 10” stump height must be felled on Project block 121701 only. All employees must be able to differentiate between species. Woody material felled using a mechanical flail type system may not have stumps with clean, sharp cuts and edges and must be less than twelve (12) inches, except when, in the opinion of the Field Contract Coordinator, said height is impractical. Woody material felled with clean cuts must have stumps that are parallel to the ground surface and shall not exceed six (6) inches in height measured on the side next to the highest ground or the diameter of the stump, whichever is smaller, except when, in the opinion of the Field Contract Coordinator, said height is impractical. Cut trees must be removed from trails, roads, tail drains, streams, and utility rights-of-way. The Contractor shall exercise care and caution in all operations to prevent damage to all trees left untreated. Damage to trails, roads, streams, or utility rights-of-way caused by the Contractor’s equipment must be repaired by the Contractor at their expense. Any trash resulting from the Contractor’s operations must be removed from the area and properly disposed.