Specifications include, but are not limited to: 1.The proposed work will include the installation and termination of all existing CAT5, CAT5E, and CAT6 cabling from existing termination panels to new CAT6 or better termination panels. 2.The proposed work must guarantee each cable is terminated and tested by certified technicians with proper test equipment. Test results of each port must be provided to the District. 3.The proposed work consists of each and every port being considered “hot” regardless of their location or connectivity status at the time of installation. 4.All new network patch panels must be of CAT6 or better quality utilizing RJ45 patch cable connections. Patch panels will all be of the same manufacturer. Hubbell (preferred) or Ortronics (acceptable alternate) are the only acceptable patch panel manufacturers. Network racks will be of the same manufacturer. Tripp Lite is the only acceptable rack manufacturer. Required part numbers are listed on the next page. All equipment/products must be new and current hardware. Used/refurbished products will not be accepted. 5.The labeling/numbering schematic currently in place with the existing terminations must be maintained and properly associated with the same wiring run when terminated into the new termination panels.