System Automatic air discharge temperature shut down switch Automatic air blow-down valve Minimum air pressure valve Starter protection switch to prevent engine overcranking Two way valve warm-up button/switch Hose Reels Two (2) Reel Craft Model C33106L or equivalent One on each side of A-frame with Chicago hose couplings mounted as close to the compressor body as possible *See Photo titled Compressor Hose Reels* Each reel should have: Shut off valve 50’ of ¾” hose with Chicago coupling A device to lock the reel in place A “crank” for each hose reel Whip checks between the male/female Chicago couplings on each reel. Use Sunitec whip checks, part no. CS-WHIPCHECK1 on each reel. Each compressor is to have a total of two (2) whip checks. *Install one (1) Chicago coupling on each side of hose reel to secure unused hose ends Line Oiler Two (2) quart, Norgren Micro Fog #L17-800-MPHA with #5605-60 sight-feed dome or equivalent to supply live reels only. *Oiler and Piping System to be securely fastened to structure to prevent movement and/or vibrations during compressor operations or transporting. Piping and elbows must be painted, coated, or stainless steel to prevent rust. Piping must be mounted near the upper driver side of front panel and clear of the hose reels. Rigid Service Lines Connected before line-oiler, include shut-off valve ¾” with Chicago coupling 3/8” with ARO #23902-210 coupling or equivalent *See photo titled Correct Fitting Orientation.jpg Flow Breaker (3) Three Thomas C. Wilson #1052-1040 @ 90psi one for each line. Installed before each hose reel and ¾” service line
