Specifications include, but are not limited to: The new fencing will act as a physical barrier and psychological deterrent against unauthorized trespassing and improve site access control. The new fencing will match existing. Extend existing fence line an additional 3463’. The new fence will be 8’ tall, requiring three (3) vehicle gates, one man gate, and Class 3 Barbed Wire, three strands each side. • Rolls of chain link fabric shall be joined by weaving a single strand of chain link into the ends of the rolls to form a continuous mesh. The fence fabric shall be tightly stretched to a tension recommended by the manufacturer and attached to the necessary posts, tension bars or gate using tension bar bands. • Frame and Install 3463 feet of linear fencing - 8ft tall- 9 Gauge Chain Link Mesh and Rail. Contractor to verify distance. • Chain link mesh shall be 8’ 9 Gauge Chain Link • Tension Wire shall be 7 Gauge. • All fitting hardware shall be galvanized steel. • Tension bars shall be galvanized steel. • Steel Tie Wires 8-1/4” x 11’ ga • 2 3/8” x 1 5/8” P.S. Eye Top • The selvage shall be knuckled at the bottom and twisted at the top of the fence • The fence shall have a bottom and top rail in all areas. • Provide and Install Class 3 Barbed Wire, three strands each side. • Dig and Set Sch 40 posts in concrete. Posts shall be installed at (10 ft) intervals. Fence posts to be plumb and straight. • All Post holes, gate and end posts must be filled with concrete. Depth in ground to be determined by location. • Line Posts 42” deep and 12” diameter hole • End Posts, Corner Posts and Slide Gate Posts 42” deep and 16: diameter hole
