Specifications include, but are not limited to: CAST IRON AND DUCTILE IRON FITTINGS Fittings shall conform to the American National Standard for Ductile-Iron and Gray-Iron Fittings, 3- inch through 48-inch, ANSI/AWWA C110; or the American National Standard for Ductile-Iron Compact Fittings, 3" through 12" ANSI/AWWA C153. Fittings larger than 12” must be C110. The length of all solid sleeves (both AWWA C110 and C153) shall be the longest length listed in the AWWA C110 specification (12-inch length for 3-inch through 12-inch sleeves, 15-inch length for 14- inch through 24-inch sleeves, and 24-inch length for 30-inch through 48-inch sleeves). All fittings shall be bituminous coated outside and cement-mortar lined inside with seal coat in accordance with American National Standard for Cement Mortar Lining for Ductile-Iron and Gray-Iron Pipe and Fittings for Water, ANSI/AWWA C104/A21.4. Unless otherwise specified below, only the following brands will be accepted for fittings made from cast iron or ductile iron Americn, Griffen, McWane, Clow, Star, Sigma, US Pipe, Tyler, East Jordan, or Pipeline Components (PCI). Mechanical joints and push-on joints shall conform to the American National Standard for Rubber Gasket Joints for Ductile-Iron and Gray-Iron Pressure Pipe and Fittings, ANSI/AWWA C111/A21.11. Flange joints shall conform to the American National Standard for Cast Iron Pipe Flanges and Flanged Fittings, ANSI B16.1. Split case iron tapping sleeves shall be 150 psi working pressure with a cast iron body conforming to ANSI/AWWA C110. Sleeve must have mechanical joints conforming to ANSI/AWWA C111 on the run and a flange branch conforming to ANSI B16.1, Class 125. Ends gaskets shall be natural rubber or neoprene material conforming to ANSI/AWWA C111. Tapping saddles for ductile pipe must be Mueller, Clow, American, Tyler, Powerseal, Smith-Blair or approved equal. Flexible stainless steel tapping sleeves shall be rated at 150 psi pressure, with flanges meeting AWWA 207. Assembly shall be NSF or UL rated. Bolts, nuts, and washers shall be stainless steel. Gaskets shall conform to ANSI/AWWA C111. Blind flanges must be fabricated from material as specified under ANSI/AWWA C200.