Fabrication Details: Front Panel: 12 Ga HR Sheet. Side / End Panel: 12 Ga HR Sheet. Floor: 10 Ga HR Sheet. Skid Channels: 10 Ga HR Sheet. Formed Channel (qty-3) Full Width, 2-1/2“ Leg x 3” Wide. Fork Pocket: 7 Ga HR Sheet, Formed 18-3/4” T x 27” L. Fork Deflectors: 7 Ga HR Gussets Located at Entrance to Pocket for Ease in Loading. Bump Plate: 7 Ga HR Formed Plate, Wrapped Around Front & Side Panel for protection. Fork Pocket Gussets: Upper – 12 Ga full length with gusset. Bottom 12 Ga formed with gussets. Top Rail: 12 Ga HR Formed Channel 1-1/4“ x 2-3/4”. Lids: Hinge Pin – ½“ HR Round Bar with ¼“ x 3” Cotter Pin Hinge Bracket – (3) Per, ¼“ x 1 ½” : Flat Bar, Punched 7 Ga Plastic Lids (single wall, double lip): • 3” Reinforced Hinge Line • Built in water Channel and drain system around perimeter of lid for easy water run off • Vacuum formed #2 HDPE Plastic process • Double Impact Hinge Line
