Specifications include, but are not limited to: FLASHING AMBER WARNING LIGHTS, 6 VOLTS Flashing Amber Warning Lights, switch controlled 6 volt, minimum 7" diameter lens, 360o degree lens rotation, water proof lens and battery case, complete with theft-proof fastening. Photo cell shall be included. Unit to be in accordance with State of Ohio Spec. 7 - 6 for Type A Barricade Warning Lights. Lights shall be compatible with Flasher Supports presently in use, and without the use of adapters. The flashing lights shall be supplied with a total of 50 fasteners, 50 each shut off keys. This unit to include circuit & lamp components. NOTE: 6 Volt, Flex-O-Lite, No. 301, or approved equal. FLASHING AMBER WARNING LIGHTS, 12 VOLTS Flashing Amber warning lights, switch controlled 12 volts, minimum 7" diameter lens, 360o lens rotation, waterproof lens and battery case complete with theft proof fastening. Battery case to be yellow in color. Unit to be in accordance with State of Ohio Spec. 7 - 6 for Type A barricade warning lights. Lights shall be compatible with flasher supports now in use, and without the use of adapters. The flashing lights shall be supplied with a total of two fastener wrenches, 5 shut off keys, and two (2) replacement parts lists. This unit to include circuit and lamp component. NOTE: 12 Volt, Flex-O-Lite, No. 301, or approved equal. FLASHER SUPPORTS ALL METAL CONSTRUCTION Portable type barricades (Slasher Supports) with spring loaded folding legs, fabricated from 1" O. D. galvanized or black iron pipe. Hot dipped, galvanized, rigid steel conduit with a 1" I. D. (minimum) may be substituted for iron pipe legs. Horizontal panel to be 36" in length and 8" in height, with type F reflectorized white paint and with orange reflectorized stripes painted at 45o angels. Panel may be covered with reflectorized sheeting consisting of 45o angle alternate orange and white stripes of a range from 5" to 7 ½" in width. The horizontal panel to be drilled or notched to accept two (2) flashing lights, one (1) mounted at each end of the 36" panel. The drilling or the notching to be of a pattern so as to maintain the flashing lights in an upright position and preventing the possibility of rotation of the light when improperly fastened. Height of unit to be 35" or 37" when in the set-up position. Barricades shall be State of Ohio Type I.