Specifications include, but are not limited to: 1.Engine:a.6-cylinder, liquid-cooled, wet-sleeve, turbocharged diesel, air-to-air aftercooled._______________________________b.Minimum 125 PTO hp, meeting US EPA Tier IV FINAL emissions standard_______________________________c.Muffler, not to impede forward view _______________________________d.Replaceable, full flow oil filter element_______________________________e.120VAC Engine block heater element, O.E. any and all aftermarket heater devices must be approved by NDDOT prior to bid award._______________________________f.Extended life anti-freeze coolant, concentration to -40degreeF_______________________________g.Foot throttle in addition to hand throttle_______________________________h.Safety interlock start switch_______________________________i.Fuel capacity to run for a 10-hour day, 70 gallon minimum_____ __________________________j.Full flow, vertical mount fuel filter w/ replaceable element_______________________________k.Fuel/water separator_______________________________l.Cold weather starting aid; intake heater type_______________________________2.Transmission, Continuously Variable Speed Type:a.John Deere IVT, AGCO CVT, Case IH CVT or equal_______________________________b.Left hand power reverser located on steering column c.120VAC transmission heater, O.E. any and all aftermarket heater devices must be approved by NDDOT prior to bid award._______________________________3.Clutch, (If Applicable):_______________________________a.Wet multi disc, hydraulic actuation4.Rear P.T.O.a.Rear 540 / 1,000 rpm, independent live operation________________________________b.Electrical switch control________________________________c.Wet disc clutch________________________________5.Front P.T.O.a. 1,000 RPM rated speed. Shaft must rotate clockwise (same rotation as rear PTO) as to allow interchangeability of implements from front to rear, e.g., 3pt snow blower_______________________________b.Front PTO to have mechanical link to engine via drive shaft, gear train, or combination of both *NOTE* (PTO Must use mechanical components where available as an O.E. option.) Hydraulic motor driven PTO may be allowed, but must be approved by NDDOT prior to award of bid. Hydraulic motor driven front PTO will only be allowed if hydrostatics is only option for front PTO. Please include literature on this system regardless of drive source