1. Install the same or equivalent one (1) Clean Energy Model Number CE330 Waste Oil Heater. 325,00 BTU/hour input. 2.3 GPH fuel consumption, 3700 CFM/85° air flow output CFM/heat rise Approximate dimensions: 111” L x 32” H x 26” W. Installed according to manufacturer requirements and recommendations. 2. New Tank Stand. 3. Acceptable Fluids: crankcase oil, transmission fluids, hydraulic oil, #2 heating oil (diesel fuel) and most synthetic oil. 4. Digital Wall Thermostat. 5. 230 VAC, 60hz, single phase 30-amp 4 wire electric circuit. 6. High velocity, stainless steel, air swept heat exchanger. 7. Vertical stainless steel flue tubes. 8. 8” chimney outlets right or left side. 9. 1,000 plus hour cleaning interval. 10.14,000 volt ignitor with Interrupted Duty. 11.UL listed, cUL listed. 12.Heating Center Tank Stand 250 Gallons including drain pan (less heater) approximate dimensions 60” L x 98” H x 30” W. 13.60 Amp Non-Fused Disconnect Switch. 14.Install (1) dedicated air compressor the same or equivalent: Gast Model 86R642- 101-N470X, Single Phase Service. Pump must be installed in an enclosure. Please provide supporting documentation. 15.Vendor shall provide product literature and warranty literature including but not limited to cabinet, heat exchanger, combustion chamber, parts, labor, etc. 16.Vendor may provide extended warranty price options. 17.Vendor may provide preventive maintenance terms, conditions, and price(S).
