Specifications include, but are not limited to: The dump body shall be of the design to accept a scissor type hoist. The body-ends must be higher than the sides, including pockets for extension side boards. The tailgate shall be double acting and must include support chains and E-Z latch type upper hinges. The body shall be made of high strength steel. The sub-frame shall consist of at least two (2) longitudinal members and the proper amount of cross-members to carry the maximum load without abnormal deflection. 10 gauge, 1/2 cab shield (24") with steel mesh window in center to be provided. Capacity, Water Level - 2 cu. yd. minimum. Capacity with Side Boards, Water Level - 3 cu. yd. Approximate Body Dimensions: approximately 78" inside width x 96-108" long x 12-14" side height x 18-20" tailgate height. Gusset Plate Height for Side Boards (inches) - 6. Longitudinal Members - 5" structural steel C-channel. Cross-members - 3" structural steel C-channel or I-beams on 16" centers. Floor - High tensile steel - 10 gauge. Sides - High tensile steel - 10 gauge with sloped running boards. Corner Braces - Shall be designed for minimum deflection while loading or unloading. Tailgate - High strength steel, 10 gauge, adequately reinforced at all sides...
