Loading...
Skip to main content
< Back to results

Truck Bodies, Cross Member-Less Dump Bodies with Cab Protectors


Location
New Hampshire
Publication Date
01/02/2019 11:34 AM EST
Closing Date
12/11/2019 11:15 AM EST
Issuing Organization
State of New Hampshire - Department of Administrative Services
Solicitation Number
Description

Specifications include, but are not limited to: 31 EACH 4 - 6 CUBIC YARD CROSS MEMBER-LESS DUMP BODIES WITH CAB PROTECTOR (UNMOUNTED/PRIMED ONLY). 13 EACH 10-12 CUBIC YARD CROSS MEMBER-LESS DUMP BODIES WITH CAB PROTECTOR (UNMOUNTED/PRIMED ONLY). • Minimum 8 gauge abrasion resistant Hi- Tensile steel construction throughout having a minimum 50,000 PSI yield strength except where material required is specifically noted later in this paragraph. • The underside of the body’s structure shall not have any open areas that would allow material to gather in and build up and to also help facilitate cleaning the body underneath. • Sides shall be reinforced with a formed top rail, formed rub rail and one (1 ea.) 8” min, full length sloped, formed horizontal brace between the top rail and rub rail per side and include 2 ea. additional 3/8” steel triangular shaped tie down plates per side with a 2” hole located between the top and middle horizontal box brace, located 15”s from the front and 21-1/2” from the rear. • All body plates, including floor, shall be one piece (splicing not allowed). • All welds in the body are to be continuous. (Fully Welded) • Body outside dimension shall not be less than 95-1/2” +/- 1/4” over wheels/tires. • Body inside dimensions shall be 9’ long by 7’ wide, with 24” sides, 4-cubic yard water level with 6-cubic yard ends. • Front sideboard pockets to be same height as cab shield and shall include a 13/16” hole located 46” on center up from the body floor. Further reinforced with a ½”X 5” X 2-1/2” stainless steel plate with a 13/16” hole shall be welded in place externally on the front of the pockets. • The outer sideboard plate at the bottom not to exceed 7” out from the headboard and at the top no more than 3-1/2” • The inside sideboard plate at the bottom not to exceed 7” out from the headboard and from the top of the side of the body taper up to 16” to a width of no more than 3” from the headboard to the finished height. • Steel sideboard fillers of width to maximum 6-cubic yard capacity, one piece, without welding and strapped and shipped on a separate pallet(s) not placed inside of dump body. • Fully welded in one piece 1/4” AR400 steel floor to include a floor to side wall 2” radius or 2”X 2” bump formed chamfer (splicing not allowed).

Get instant access

Get instant access to solicitation details & future business opportunities.

to solicitation details & future business opportunities.

Get Access

Vendor packages with access to similar open solicitations

Matching bid notifications & access to all Statewide & Group bid details

Statewide

Matching bid notifications & access to all Statewide & Group bid details

Matching bid notifications from participating agencies

Group

Matching bid notifications from participating agencies

Access participating agency bids

Basic

Access participating agency bids