Specifications include, but are not limited to: BASE: Fully hydraulic capable of being mounted in a manner which minimizes fastening problems caused by flexing of the truck
frame. Cab to body dimensions for this mounting application -36” maximum.
MAST: Mounted behind the hydraulic wing cabinet that will be in place at mid-point of the frame width. Must provide for good
visibility permitting safe operation when operator is using controls from either side of the truck.
BOOM AND BOOM ROTATION: Boom shall be fully hydraulic telescoping type. Retracted length shall be approximately 6-1/2’
feet. Extended length shall be minimum 15 feet. Boom lifting capacity shall be minimum 2,850 lbs. @ 13 feet.
Extension/Retracting cylinder(s) to be DA, externally or internally mounted. Boom elevation to be minimum 80 degrees above
horizontal. Swing assembly shall be at the base of the unit and shall rotate a minimum of 200 degrees around rear of truck. ; HYDRAULIC RESERVOIR AND FILTRATION: Tank capacity 37 gallons minimum. Reservoir to be baffled for optimum mixing and
cooling. Return piping shall be adequately sized for proper flow. Tank filler shall be equipped with dust cap. A 3/4” magnetic
drain plug shall be located in the bottom of the tank. Return oil shall pass through an external filter, equipped with bypass valve
and condition indicator.