Part A – Snowbase Compressor Replacement 1. Supply and install a new System Air Compressor ( or similar) with the following specifications: • Same as current size-gallon tank (vertical or horizontal configuration acceptable) • Air-cooled aftercooler • Low oil stop control • Electronic tank drain • Vibration isolation • 3-phase motor • Minimum 25 HP motor • Ability to reach 175 PSI 2. Install and verify full operational status of the new compressor. Part B – Peabody Compressor Replacement 3. Supply and install a new System Air Compressor (or similar) with the following specifications: • 80-gallon vertical tank • Ability to reach 175 PSI • 3-phase motor • Low oil stop control • Electronic tank drain • Air-cooled aftercooler • Vibration isolation appropriate for nearby vibration-sensitive equipment 4. Install and verify full operational status of the new compressor, including proper plumbing and integration with the existing air dryer. 5. Service and verify operational condition of the existing air dryer at the Peabody location. Remove and replace if necessary. Part C – Snowbase Centac Compressor Stage Service/Rehabilitation 6. Take the existing Centac compressor offline and safely isolate it. 7. Remove, clean, and/or replace stage 1 and stage 2 components. 8. Disassemble unit, pressure wash, and soak necessary parts. 9. Reassemble using new gaskets, seals, and bearings. 10. Pressure test and visually inspect the cooler for wear; repair or replace components as needed. 11. Verify proper operational status and correct operating temperature after reassembly. 12. Return the Centac compressor to online service.
