3. BRAKES 3.1 Power hydraulic type, four-wheel vented-disc brakes. 3.2 Standard ABS system 3.3 The unit shall include an electric brake controller and have a wired seven (7) wire plug at the rear of the vehicle for trailer towing purposes. 4. САВ AND BODY 4.1 Structure to be standard manufacture and weatherproofing. Extended length cab. 4.2 All windows shall be safety glass. 4.3 Front seat shall be a 40/20/40 cloth/fabric bench seat with adjustable driver and passenger settings. 4.4 Speedometer (MPH) with odometer. 4.5 Oil Pressure gauge and low-pressure light. 4.6 Water temperature gauge with high temperature warning light. 4.7 Fuel level gauge. 4.8 Tachometer. 4.9 Voltmeter. 4.10 Any other gauges recommended by the manufacturer. 4.11 Cruise control. 4.12 Heavy duty type fan or blower type hot water heater capable of providing sufficient cab heat and defrosting the windows during adverse winter weather. Heater shall be equipped so that the operator has the choice of fresh air or recirculated air. A multi speed fan control. Factory installed air conditioning. 4.13 Vinyl Floor mats with acoustic noise-reduction backing. 4.14 Sun visor L.H. and R.H. 4.15 Electric intermittent windshield wipers. 4.16 AM/FM radio. 4.17 Dome Light. 4.18 Backup Camera installed with dash feedback view. 4.19 Four Wheel Drive 4.20 Power Windows 4.21 Power locking doors 4.22 Tilt Steering wheel 4.23 Auxiliary/Upfitter switches to be in overhead position. 5. CHASSIS/FRAME 5.1 Wheelbase with the ability to have a standard long bed. 5.2 Steel frame. Minimum 56.2 inches cab to axle. 5.3 Mínimum 30 gallon capacity fuel tank. 5.4 Factory equipped power steering. 6. COOLING SYSTEM 6.1 Equipped with factory heavy duty cooling system. 6.2 A factory installed fan clutch. 6.3 Electric block heater shall be installed. 6.4 A transmission cooler is required. 7. COLOR 7.1 Paint color shall be manufacturer's standard white. 8. ELECTRICAL SYSTEMS 8.1 Lights and signals must comply with all current federal and state requirements. Rear tail lights will be LED and easily seen. 8.2 All exterior lights shall be LED. 9. ENGINE 9.1 Engine shall be 350 Horsepower minimum and 825 ft. lb. of torque, minimum. Tier IV compliant. List pricing for different options. 9.2 Exhaust system shall be standard manufacturer's recommend horizontal exhaust. 9.3 Engine shall be equipped with compatible engine retarding brake or equivalent. Braking system shall provide for selection of application rates. 10. FILTERS 10.1 Engine shall be equipped with both primary and secondary (if applicable) fuel filters to provide for severe duty service. 10.2 All filters shall be spin-on type if applicable for engine offered. 10.3 Engine lubricating oil filters shall have a capacity to accommodate severe duty conditions. Filters shall be located for replacement ease without removal of lines or other parts. 10.4 All filters recommended by the manufacture shall be required whether mentioned or not. All filters shall be located for ease of replacement.
