****SOLICITATION RESPONSE DATE EXTENDED TO 16 JUNE @ 1700 EDT****
This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; quotes are being requested and a written solicitation will not be issued. Note: This acquisition is subject to the availability of funds.
INTRODUCTION: The AFCEC has a requirement to upgrade a 2024 Ford-550 truck with a new steel utility truck bed. The Government is seeking a contractor to provide and install a new steel utility truck bed on the vehicle as specified below. The AQD is issuing this competitive RFQ as 100% set aside for small business.
OVERVIEW OF THE REQUIREMENT: This acquisition is to provide and install the exact required commercial end item of supply with the required specifications below on or before September 1, 2025. The Government intends to drop-off and pick-up the vehicle at the location of installation given the driving distance does not exceed 100 miles from the address below:
Nellis AFB
4701 N Torrey Pines Dr
Las Vegas, NV 89130
Vehicle Specifications:
VIN: 1FD0W5HT1REC31415
Model Year: 2024
Make: Ford
Model: F-550
Build Date: November 2023
Cab to Axle: 60 INCHES
Bed Length: 9 FEET 4 INCHES
Width: 96 INCHES
Service Truck Bed Specifications and Requirements: The service truck bed to be procured and installed must meet or exceed the following specifications:
Dimensions & Structural Requirements:
LENGTH: 9 FEET 4 INCHES
HEADACHE RACK: Steel Tube
DECK: 1/8 INCH Treadplate
FRAME RAILS: 4 INCH Structural Channel Steel
CROSSMEMBERS: 3 INCH Roll-Formed 3/16 INCH Channel Crossmembers
Towing & Electrical:
BP HITCH: 24K lb. 2 1/2 INCH B&W Hitch with Receiver Tube
GN HITCH: 30K lb. B&W Hitch with Welded Ball
FUEL FILL Kit: Angled
12V TRAILER PLUG: Round 7 Pin in GN Box, round 7 Pin/4 Way Flat on Rear
Lighting & Accessories:
REAR LIGHTING: Clear LED Oval
LIGHT BOX (REAR SKIRT): Steel
MARKER LIGHTING: Bullet DOT Approved
LED TOOLBOX: Utility Box in Front, Top-Open 3/4 Length Shovel Box; Low-Profile Chain Box in Rear
TOOLBOX HANDLE: Chrome T Handle Compression FENDERS Steel Welded-In
SIDESTEPS: In Front of and Behind Fender
TIE DOWNS: 4 Airline Track Tiedowns, 4 Attachment Rings
MUD FLAPS: 24x24 INCHES
BACK UP: Back up sensors and camera
Installation Requirements: The selected vendor will be responsible for the full installation of the service bed onto the identified vehicle. Installation must comply with all applicable safety standards, and all wiring, fuel access points, and hitch components must be fully functional and tested prior to delivery.
