Specifications include, but are not limited to: This vehicle to be used as an electrical substation utility truck. The body is to be installed on an LES supplied chassis (F-550 regular cab) by LES approved distributors and to comply with all current applicable OSHA, ANSI and DOT Standards. Interior body dimensions to be 14’ long x 84” high x 96” wide New current model high cube body to be mounted on a usable 108” CA chassis with a 193” wheel base Full width galvanized grip-strut rear bumper to include access for receiver for pintle hook hitch. A fold down step to be equally spaced from ground to first step. The fold down portion to be full width of main door opening at the rear A class five 2” receiver to be built into rear bumper and reinforced into truck frame with safety chain “D”-rings on rear of hitch. Center of 2” receiver hitch to be 20” +/- 1” from the ground. A six pin round Cole Hersee #1235 or equivalent trailer light socket installed to the street side of the receiver hitch area with all splices soldered and covered with heat shrink material. NO Scotch locks allowed. Wire the OEM trailer brake controller into the accessory terminal of the light socket and the center terminal to be wired to a 12 volt “ignition hot” circuit and fused to 20 amps
