Specifications include, but are not limited to: New current standard model Fiberglass line body Installed on LES supplied chassis by manufacturer or LES approved distributor and comply with all current applicable OSHA, ANSI and DOT standards BODY AND MISCELLANEOUS ITEMS DETAILS: Fiberglass constructed line body for installation on a 60” CA chassis with dual rear wheels All doors weather sealed, water tight and keyed alike Rotary styled paddle latches on all compartment doors 3/16” steel tread plate load area floor and tail gate All compartments equipped with fiber-glow “rope type” lights at top and both sides of each compartment with lighted rocker style master switch installed on the “run” side of the chassis ignition switch Minimum 6 inch clearance between rear tires and body/fender skirt for tire chain clearance Mud flaps behind rear wheels LED type body lights flush mounted and conform to FMVSS 108 to include reverse lights also 3/16” flat steel head board with ¼” thick smooth steel cross member Master body locking system with handles located at rear of body. Horizontal compartments will have two (2) locking points on each side of compartment in lieu of center All vertical body pack doors are to have self-centering door openers to hold the doors in the open position but allow the doors to be shut with no other action from personnel Rotary paddle latches with locks and keyed alike on all body compartments BODY DIMENSIONS: 108 inches nominal overall body length 94 inches outside body width 40 inches body height No wheel wells in body floor area 20 inch deep compartments