Specifications include, but are not limited to: Contractor will provide all labor, equipment, materials, incidentals and traffic control necessary to produce, haul, place, tack and compact approximately 6,222 tons of ½” Commercial Plant Mix Grade S 64-28 asphalt mix material. Leveling course of 1,000 tons shall be placed in areas where needed and compacted prior to placing overlay. The overlay shall be paved 0.15 feet thick and approximately 25 feet wide. There is one bridge within the project that will need 50’ milled tapers on each end plus the starting and ending connections to the existing pavement. Contractor shall provide all labor, equipment, materials, traffic control and incidentals necessary to produce, haul, place, roll and broom approximately 59,825 square yards of laid-in-place chip seal. The chip seal will be approximately 4.08 miles long and 25 feet wide. Contractor shall provide CHFRS-2P asphalt emulsion & Type 1 chips. Traffic control with pilot cars must be maintained until dusk or fading light each workday as determined by the Project Manager. The emulsion application rate for chip seals is estimated at 0.43 gallons per square yard. The cover material application rate is estimated at 25 pounds per square yard. Actual application rates will be based on the chip design and the actual field adjustments. If the cover material application rate of 25 pounds per square yard is not sufficient to provide a quality job, the Project Managers will jointly determine what the new application rate should be. Contractor must furnish a water truck for dust control and wetting of chips. Arrangements must be made by the Contractor for acquiring water for wetting and sweeping. It will be the responsibility of the Contractor to determine the centerline and place reflective tabs prior to the chip seal. The Department will provide final striping. Contractor is responsible for test trailer, transport, and setup. If the Department decides to perform testing at an area lab, this bid item will be deleted from the contract. The quantity is estimated and will be changed accordingly depending on pickup and delivery locations and miles transported.