Specifications include, but are not limited to: NEW CHAIN LINK FENCE A. This work consists of installing new chain link fence where shown on the plans, or as directed by the Engineer. B. Chain link fencing shall conform to this specification and to the details shown on the plans. Fence materials shall conform to the following: C. Chain link fence fabric shall be No. 9-gage (0.148 inch) zinked steel wire woven in two (2) inch mesh with top and bottom of fabric knuckled. The fabric shall conform to ASTM A117. D. The woven wire fabric shall be made of zinked or aluminized steel wire. Zincked fabric shall conform to the requirements of ASTM A116-73, Class-3 Coating. Line wires shall have tension curves. Aluminized fabric shall conform to the requirements for zincked fabric except that the coating shall be aluminum alloy applied at the rate of not less than 0.25 oz. per square foot of uncoated wire surface. E. Posts, braces and tie rods shall be of the size indicated in the plans. All ferrous materials shall be galvanized; the zincking shall weigh not less than two (2.0) ounces per square foot of actual surface. Tubular sections shall be zincked both inside and outside. F. Concrete footing, where required, shall be MCIB Mix No. A465-1-6. See plans for details of fence post installation on retaining walls. NEW WOOD FENCE A. This work consists of installing new wood fence to match the existing wood fence. B. All new fencing material shall be pressure treated or cedar and match the existing wood fence. C. Privacy Fence filler material shall be constructed to match the existing fence as required. All wood shall be free from insects and/or insect damage. D. The fence shall be installed as shown on the plans and with the manufacturer’s instructions and approved by the Engineer. Concrete for footings shall be MCIB Mix No. A465-1-6.