Specifications include, but are not limited to: Broadband connectivity - Must use Business Class DSL - Must provide a public routable static IP address for 1 host - Must use a DSL modem with 4 port integrated switch and routing functions for multiple devices - Should not use point to point wireless connectivity - Must use a minimum broadband connectivity speed of - 384 kbps upload 1.5 mb download - Should not share Broadband connection with other businesses LAN Cabling - Must provide dedicated cabling to be run from each network device to a centralized location - Must use Category 5 or above cabling - All network connectivity devices (firewall, hubs, DSL modem) must reside within 2 feet of each other. - Network cabling must follow industry standard guidelines and local code regulations Drivers License requirements - Dedicated 20 AMP power circuit within 4 foot of the installation site. Must have a minimum of 2 available plugs - Distance from the installation location of the camera to the area of the backdrop is a minimum of 78 which will allow for a 60 clearance from front of camera lens to front of the subject. - Height of Camera Counter should allow for Camera Lens to be 48 to 53 from floor. - Cat 5 Ethernet connection is required to be within 15 of Computer cabinet or table - CPU should be placed on table or counter or housed on a shelf enclosure that allows for adequate air movement in and around CPU case. CPU should not be placed on the floor or in a enclosed housing without ventilation - Card printer must be placed in a well ventilated area. - All hardware is to be installed on stable secure counters or tables. No part of the Hardware components should extend past the surface of counters or tables that are used to house the operating equipment. Hardware should be installed with all cords protected from traffic ways and subject to interference by customers. - Camera to backdrop area should not be a common foot traffic area. No traffic should be allowed to pass between the camera and the backdrop except to capture a photo. Miscellaneous - Network equipment should reside in a closet. - Must provide the state agency with an office wiring diagram depicting office furniture, counter space, walls, doors, LAN cabling, power outlets to state owned equipment within 30 days of office opening - Must provide dedicated single socket electrical receptacle for networking equipment - Must only connect state owned or state approved equipment to the State of Missouri provided firewall or router - All networking equipment must be connected to a surge protector - All network connectivity equipment must reside within the following environmental conditions: - Temperature: 32 to 104F (0 to 40C) - Relative humidity: 10 to 90 percent, noncondensing - Altitude: 0 to 6500 feet (2000 m) - Shock: 250 G, 2 ms - Vibration: 0.41 Grms2 (3-500 Hz) random input - Must agree that any non State of Missouri equipment connected directly to the DSL modem will not be supported by State of Missouri staff, or failures resulting from this equipment - All network equipment must be visible and openly available for routine maintenance. Must include no physical obstructions within 1 foot of the equipment.
