4.1. Aerial Unit Specification Requirements The aerial lift specification requirements shall be as follows: 1. 55' working height and include base assembly supporting front mounted rotating turret, hydraulically powered continuous rotation mechanism, oil reservoir mounted to truck frame, oil, and manual hydraulic controls mounted to turret. 2. Electronic proportional three (3) stick remote controls on the platform. 3. Base mounted "A" type hydraulically powered individually controlled main outriggers. 4. Underslung "A" type outriggers for rear stabilization. 5. High strength steel three (3) section hydraulically telescoping boom with one (1) double acting 6" lift cylinder. 6. One (1) cable carrier to boom tip with cover. 7. Hydraulically self-leveling 40"x60" top mounted work platform with hydraulic platform rotation and remote leveling from platform. 8. Step to access platform from bed (if space allows). 9. Power take off and pump drive, pressure gauge, pump and holding valves on all cylinders. 10. Remote start/shutdown at upper and lower controls, 12-volt emergency pump with switch at upper and lower controls, PTO hour meter, backup alarm, fire extinguisher, and two (2) body harnesses, triangle kit and lanyards. 11. LED lights to include all bed marker lights, stop, tail and turn. 12. Installed on chassis, tested and ready to operate. 13. Unit certified to ANSI A92.2 for Vehicle-Mounted Elevating and Rotating Aerial Devices. 14. Platform capacity 600lbs. 4.2. Chassis Specification Requirements The chassis specification requirements shall be as follows: 1. 300 hp diesel engine (660lb/ft) 2. 204 WB 3. 137" C.A. 4. 96" AF, 5. 6-speed automatic transmission 6. 33,000 GVWR 7. 13,000 lbs front axle 8. 20,000 lbs rear axle 9. 11R22.5 front tires 10. 11R22.5 rear tires 11. 2 front tow hooks 12. Air brakes ABS 13. Block heater 14. 50 gallon aluminum fuel tank 15. Cruise control 16. Bluetooth radio 17. Air conditioning 18. Air ride driver seat/two (2) man bench and 19. Color - white.
