Specifications include, but are not limited to: Pumps Must be 6 in. discharge, 40 horsepower, including 6 in. x 6 in. discharge base elbows. Pumps shall operate on 3 phase, 60HZ, 480volt power. Pumps shall be non-clogging chopper variety delivering solids size reduction. Pumps shall have heat treated 440c stainless cutter blades capable of handling solids larger than 3 in. Pumps must employ quick disconnect cords; a minimum of 50 ft. in length. Blades must be field replaceable. Pumps shall have stainless lifting bails, VRD ready motors with 1.2 service, factor, class H magnet wire, tapered key shaft. Stainless hardware, heat treated open center design blades. Liquid cooled motor with high capacity (50,000 hour bearing life at 2 ft /sec flow). Pumps shall be coated with Axalta Epoxy. Slotted Discharge that adapts to ANSI and ISO flanges.